Yeedi vac 2 Manual De Instrucciones página 8

circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Caution: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science
and Economic Development Canada's licence-
exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
RF exposure warning
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment.
MPE caution (for mobile device under Part 15.247
& 15.407 device)
To satisfy FCC&ICRF exposure requirements, a
separation distance of 20cm or moreshould be
maintained between the antenna of this device
and persons during device operation.
To ensure compliance, operations at closer than
this distance is not recommended.
To disable Wi-Fi module on DEEBOT, power the
robot ON. Place the robot on the Docking Station
making sure the Charging Contacts on DEEBOT
and the Docking Station Pins make a connection.
Press and hold the AUTO Mode Button on the
robot for 20 seconds until DEEBOT emits 3 beeps.
To enable Wi-Fi module on DEEBOT, power the
robot OFF and then power ON. The Wi- Fi module
is turned on when DEEBOT is restarted.
This Device Complies with DHHS Radiation Rules,
21 CFR Chapter 1,Subchapter J.
7
EN