Electrical Safety; Assembly And Adjustments - Black and Decker BEPW1300 Traducido De Las Instrucciones Originales

ENGLISH
Labels on tool
The following symbols are shown on the tool along with the
:
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
f
Wear eye protection.
g
Wear ear protection.
Machine not suitable for connection to the potable
water mains.
Directive 2000/14/EC guaranteed sound power.
92
BEPW1300
Directive 2000/14/EC guaranteed sound power.
91
BEPW1700
Directive 2000/14/EC guaranteed sound power.
93
BEPW2000
#

Electrical safety

This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
Features (Fig. A)
1. High pressure hose
2. Spray wand
3. Nozzle button
4. Spray handle
5. Spray handle grip
6. Trigger lock‑off
7. Trigger
10
(Original instructions)
Never direct the water
jet at people, animals,
the machine or electric
components
8. Spray fan to pencil jet nozzle
9. Hose connector
10. Filter
11. Soap bottle
12. Soap bottle applicator
13. Hose connect button
14. Nozzle cleaning tool
15. Turbo nozzle (BEPW2000)
16. Pressure washer unit
17. ON/OFF dial
18. Handle
19. Retractable handle (BEPW1700, BEPW2000)
20. High pressure water outlet
21. Cord retaining hook
22. Power cord
@

Assembly and Adjustments

WARNING: Before attempting any of the following
operations, make sure that the tool is switched off
and unplugged.
Attaching Spray Handle (Fig. B)
1. To connect the spray handle ( 4 ) to the spray wand ( 2 ),
insert the end of the spray handle onto the end of the
spray wand.
2. Press in and turn the spray handle counterclockwise to
lock it into position.
Attaching High Pressure Hose (Fig. C)
NOTICE: Never pull high pressure hose or water
supply hose to move pressure washer. This could
damage hose and/or pump inlet and/or pump outlet.
1. To connect the high pressure hose ( 1 ) to the
spray handle ( 4 ), depress the hose connect button ( 13 )
while clicking the hose end ( 23 ) into the spray handle.
Release the hose connect button when the hose end has
clicked into position.
2. To connect the high pressure hose to the pressure washer
unit ( 16 ), screw the hose collar ( 24 ) onto the high
pressure water outlet ( 20 ).
NOTE: Uncoil the high pressure hose before installation to
prevent kinks.
NOTE: Avoid cross threading when installing the hose.
Cross threading will cause leaks.
Attaching Garden Hose (Fig. D, K2)
NOTE: Before connecting the garden hose to the pressure
washer unit, run water through the garden hose for thirty
seconds to clear any debris from inside the garden hose.
1. To connect the garden hose to the pressure washer
unit ( 16 ), screw the filter ( 10 ) to the water intake ( 25 ).