DeWalt DW733 Traducido De Las Instrucciones Originales página 21


WARNING: Feed the workpiece in the direction of the grain (Fig. G).
Snipe
Snipe is a depression made when the ends of the workpiece contact the cutters. To
avoid snipe:
• Make sure the extension tables are level with the main table.
• Keep the workpiece level throughout the planing operation.
• Feed the workpiece flat against the tables.
Warping (Fig. H1–H4)
If your workpiece is only slightly warped, plane both sides to produce the desired thickness.
Bowed Workpieces (Fig. H1, H2)
The feed rollers and cutterhead will temporarily flatten the workpiece (Fig. H1). The bowed
shape, however, will return after planing (Fig. H2).
To remove the bow, use a jointer.
Cupped Workpieces (Fig. H3, H4)
1. Rip the cupped workpiece in the middle (Fig. H3).
2. Plane the pieces separately to eliminate waste.
3. Alternatively, plane the top flat 38 first, then turn the workpiece over and plane the
bottom flat 39 (Fig. H4).
Transporting (Fig. A1, A2)
• Always transport the machine disconnected from power supply.
• Wind the supply cord at the cord wrap
• Always carry the machine by both carrying handles
• The machine should be carried by two persons.
• Check the tool for damage before use after transporting.
Storage
• Alway sore the machine switched off and disconnected from power supply
• Store the tool at a cool and dry place.
• Store the tool in a place where they cannot be accessed by children or
unauthoized person.
• Chek the machine for demage before using after a long periode of storage.
MAINTENANCE
Your D WALT power tool has been designed to operate over a long period of time with a
e
minimum of maintenance. Continuous satisfactory operation depends upon proper tool care
and regular cleaning.

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Resharpening the Blades
The blades can be resharpened at 42 °.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Vacuum dirt and dust out of the main housing with a suitable vacuum
cleaner as often as dirt is seen collecting in and around the air vents. Wear approved eye
protection and approved dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic
parts of the tool. These chemicals may weaken the materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.

WARNING:
• Keep the tables clean and free from grease. Regularly apply some wax to the tables.
• Keep the machine free from dust and shavings.
Before use, carefully check the cutterhead to determine that it will operate properly. Ensure
that dirt, dust or workpiece particles cannot lead to blockage of one of the functions.
In case of workpiece fragments jammed between cutterhead and infeed roller, disconnect the
machine from the power supply and remove the jammed parts.
Optional Accessories

WARNING: Since accessories, other than those offered by D
with this product, use of such accessories with this tool could be hazardous. To reduce the
risk of injury, only D WALT recommended accessories should be used with this product.
e
Consult your dealer for further information on the appropriate accessories.
12 to keep cord in place.
4 or handholds 7 .
WALT, have not been tested
e
Protecting the Environment
Separate collection. Products and batteries marked with this symbol must not be
disposed of with normal household waste.
Products and batteries contain materials that can be recovered or recycled reducing
the demand for raw materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at www.2helpU.com.
EngLIsh
19