Safety Advices - KPS TP5000HY Manual Del Usuario

TP5000HY
• Resistor
Range
9999Ω
50.00kΩ
Output Voltage : about 0.5V
Overload Protection : AC/DC 1000V
• Continuity
Continuity : The built-in buzzer sounds in the case of measuring resistance less
than 1.8kΩ and may be up to 2.7kΩ. LED RX shows at the same time.
Continuity Indicator : 2.7kHz Tone Buzzer and RX LED
Response Time of Buzzer : < 100 msec.
Output Voltage : about 0.5V
Overload Protection : AC/DC 1000V
• AC Ampere
Range
200.0A
Frequency Response : 45Hz to 65Hz
Overload Protection : AC/DC 200A
• Rotary Field Indication
For 3 phase 4 wire system only
Sensitivity : 90V to 1000V (Phase-to-ground)
Frequency Range : 45Hz to 65Hz
"L" LED is on when the signal of L2 probe lead the signal of
L1 probe; "R" LED is on when the signal of L1 probe lead
the signal L2 probe.
• Single-Pole Phase Check
Sensitivity : 90V to 1000V (Phase-to-ground)
Frequency Range : 45Hz to 65Hz
Indicator : 2.7kHz Tone Buzzer and ELV LED

SAFETY ADVICES

Depending on the internal impedance of this meter there will be a
different capability of indicating the presence or absence of operating
voltage in case of the presence of interference voltage.
When in contact with the parts to be tested, this meter may discharge
temporarily the interference voltage to a level below the ELV, but it will
be back to the original value when this meter is removed.
When the indication "voltage present" does not appear, it is highly
recommended installing earthing equipment before work.
When the indication "voltage present" appears on a part that is
expected to be disconnected of the installation, it is highly
recommended confirming by another means (e.g. use of an adequate
voltage detector, visual check of the disconnecting point of the electric
circuit, etc.) that there is no operating voltage on the part to be tested
and to conclude that the
voltage indicated by this meter is an interference voltage.
Resolution
1Ω
±(1.5% + 5D)
0.01kΩ
Resolution Accuracy
0.1A ±(3.0% + 5D)
08
Accuracy
EN