Safety - KPS TL300 Manual De Instrucciones

1. Safety

The earth resistance tester (hereinafter referred to as meter) , which is up to GB4793.1, the requirement on the safety of electronic
measurement instruments, is designed and manufactured in accordance with EN 61010-1, EN61010-2-030 Safety Standard, regarded as
Grade 2 pollution, and the maximum voltage for the meter to probe can not exceed CAT III 300V.
The users' manual includes cautions and safety regulations, which specifies the rules in usage of the meter to avoid personal injury accident
and long keep the meter in good condition, therefore, please read the manual before using the meter and adhere to the operation instructions
inside it, and inobservance of the manual in using the meter may cause personal injury or damage to the meter. Protection impairment if
used in a manner not specified by the manufacturer.
Safety Symbols
Danger: improper operation will cause severe or fatal injuries.
Warning: improper operation may cause severe or fatal injuries
Caution：improper operation may cause personal injuries or damage to the meter
Equipment protected throughout by double insulation or reinforced insulation
CAT III (measurement category III): Applicable to test and measuring circuits connected to the distribution part of the
building's low-voltage MAINS installation.
Danger
Check if the rotating switch is set to a proper position before measurement
Never use the meter in the vicinity of explosive gases, steam or dust.
Never connect wires or probes with wet hands or when the surface of the meter is humid.
Don't touch the testing wires or probes in a measurement.
Don't open the battery cover when the meter is working.
Warning
Never proceed a measurement under abnormalities, for example, the housing of the meter has been damaged so that the metal of the meter or wires are
naked.
Never replace the parts of the meter by yourself or modify it. Should the meter be damaged, return it tothe local dealers for examination or repair.
Don't replace the batteries when the surface of the meter is humid.
Be sure to set the switch to "OFF" and disconnect the testing wires before replacing the batteries.
1