2. Connect to power supply
After connecting to power supply, the
refrigerator is in the default status, and
it shows the actual chilled and frozen
temperature. The refrigerator has a
Power-down memory, the first time
when it is power on, and then every
time will be set up at the last power-
down operation.
3. Work model of the refrigerator
You can choose one of the following
two models of refrigerators to set up.
Intelligent mode: If there are not
special needs, we recommend that
you use the intelligent mode, because
the refrigerator will work automatically.
Manual mode: You can use
Temperature Control keys to set the
temperature.
4. Store the food into the refrigerator
After a couple of hours of operation,
the interior of the unit will be cool
enough to start the storage, then you
can place the food into the refrigerator.
Attention
Please do not use any electronic equipment or methods for defrosting, except the one
recommended by the manufacturer.
Refrigerant R600a and foaming material Cyclopentane are combustible, please keep the
unit far from heat source and no fire shall be enlighten on it.
The power cable should not be pushed by the refrigerator unit or any other object.
Before connecting the unit, please check the voltage of refrigerator and power supply
carefully.
When the temperature is set to change or put new food into the refrigerator, It takes
some time to balance the inside temperature. The length of this period depends on the
size of the temperature change. The temperature of surrounding environment, the
frequency of opening door and the number of food, and so on.
27
All manuals and user guides at all-guides.com
Compartments
Refrigerator compartment
The temperature inside the
°C
refrigerator will be between 0 -10
,
so please use this compartment to
store any food that can be preserved
at this temperature and not for long
periods of time.
Shelf adjustment
You can adjust the shelf to proper
position, please move the shelf by the
direction(1),then turn the shelf as
direction(2) for 90°until it is
Perpendicular to the original direction,
then pull out the shelf as direction (3).
Height adjustment and cleaning of
shelves
Lift the shelves as direction (1), hold
both sides, and then pull it out as
direction (2). After cleaning, you can
also adjust the position according to
the height of stored foods.
28