ProBreeze PB-15 Manual De Instrucciones página 7

OPERATING INSTRUCTIONS
― ―
Control Panel
Buttons
Note: for safety reasons and to regulate
temperature, the fan will continue to run when
the compressor is off.
• Auto / Comfort: Press once to start auto
mode. This will automatically set the
room humidity to 45-55% based on the
room's environment.
• Filter:
• The filter light will flash after 250
hours of operation as a reminder
to clean the filter on the unit. Once
cleaned, press the filter button once
to reset.
• To connect the unit to wifi, hold the
filter button down for three seconds
until "AP" shows on the LED display
and follow the instructions below.
Cont: press once to activate continuous
•
dehumidifying mode. Before doing so,
connect the drainage hose to the back of
the unit.
• Turbo: press once to start Turbo Mode.
This will increase the fan speed to
maximum. Press again to reduce the fan
speed.
Timer: this button controls the auto-start
•
and auto-stop functions.
• For auto-start, turn the unit off
using the power button. Press the
timer button until the "on" light
illuminates. Use the arrows to select
the auto time (available in 30 minute
increments, up to 24 hours). Once
selected, wait five seconds. The LED
display will return to blank. The unit
will turn on after the time has been
reached.
• For auto-stop, turn the unit on
using the power button. Press the
timer button until the "on" light
illuminates. Use the arrows to select
the auto time (available in 30 minute
increments, up to 24 hours). Once
selected, wait five seconds. The LED
display will return to showing the
RH. The unit will turn off after the
time has been reached.
• Turning the unit on or off, or
reducing the time to 0 will turn off
timer mode. The unit will turn off
after the time has been reached.
• Up / Down Buttons: press to control the
humidity level. The humidity level can
be set from 25% RH to 85% RH in 5%
increments. For drier air, set a lower RH.
For damper air, set a higher RH.
Lights
• Auto, filter, continuous lights: these will
illuminate when the modes are activated.
• Defrost: this will illuminate when frost
builds up on the evaporator coils. When
this happens, the compressor will turn off
and the fan will continue to run until the
coils defrost.
• Full: this will illuminate when the water
tank is full and needs to be emptied. To
empty, follow the instructions listed below.
English | 6