Tilt Stand; Commissioning; Connecting The Test Leads; Switching On, Switching Off The Instrument - Metrix MX 553 Manual De Instrucciones

Polimetro de sobremesa
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2.6.

Tilt stand

- Push both latching devices as indicated by the arrows.
- Adjust the handle to position to the required angle.
- Release the latches.
3.

COMMISSIONING

3.1.

Connecting the test leads

Connect the black lead to the COM socket (for all measurements). Depending on the
position of the selector switch, connect the red lead as follows:
V
10 A
5 mA
3.2.

Switching on, switching off the instrument

Switch on the instrument by pressing the M/A key.
All segments of the display come on for a few seconds. The instrument is then ready for
measurements.
Switch off the instrument by pressing the M/A key.
3.3.

Special configurations

To adapt the configuration of the instrument the environment, the user can:
- Choose 50 Hz or 60 Hz rejection:
Switch on the instrument and keep the MEM key down. The selection is reversed
from the last configuration, is displayed for two seconds and remains backed up in
non-volatile memory.
- Choose a low resolution mode (5 000 points):
Switch on the instrument and keep the REL key down. The selection is displayed for
two seconds.
20
Rotary selector switch position
, Ω,
, mV
, V
AC
DC
DC
DC
, 50 mA
, 500 mA
DC
DC
Input terminal
VΩ
A
mA
DC
Chapter II
Benchtop multimeter

Publicidad

Tabla de contenido
loading

Tabla de contenido