Evolution R185 SMS Li Instrucciones Originales página 48

Fig. 10
Fig. 11
Fig. 12
Fig. 13
RESETTING THE LOCATING LUGS
• Gently push the protruding lug into the Carriage arm.
• Gently ease the locating lug deployment plunger forward
by using a flat bladed screwdriver (not supplied) as a lever.
(Fig. 10)
The carriage slides two arms should be inserted through the
two linear bearings contained within the bevel neck.
The carriage slide should be inserted from the back ensuring
that the 'Evolution' logo is the correct way up. (Fig. 11)
• Slide the sliding carriage arms through the bevel neck for
approximately half of their length.
• Screw the carriage slide locking screw into the threaded
hole above the right hand arm of the carriage slide.
(Fig. 12)
Note: Ensure that the anti-vibration spring is fitted
underneath the hand knob before fitting the locking screw
into its service position.
• Tighten the locking screw to lock the sliding carriage into
the desired position.
ATTACHING THE CUTTING HEAD
• Align the cutting head with the two sliding carriage arms.
(Fig. 13)
• Push the cutting head onto the Carriage arms firmly until
the 'click' of the Locating Lugs deploying is heard.
Note: The deployed locating lugs must be fully visible when
viewed from the side of the cutting head. (Fig. 14) The
Locating Lugs are coloured green to make identification easy.
THE MACHINE TABLE EXTENSIONS (7 - on machine
overview)
Note: Two machine table extension pieces are provided with
this machine.
TO FIT THE TABLE EXTENSIONS:
• Remove the socket headed screws (29 - on machine
overview) from the table using the hex key provided.
• Position the relevant Extension piece onto the table and
secure it into its service position using the socket headed
screws.
• Repeat for the second Extension piece.
48
www.evolutionpowertools.com