Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Needles Breaking
Possible cause:
Bent, dull or damaged needle.
Solution:
Discard needle, insert new needle.
Possible cause:
Wrong size needle for fabric.
Solution:
Insert appropriate needle for fabric type.
Possible cause:
Machine not threaded correctly.
Solution:
Rethread the machine completely.
Possible cause:
"Pushing" or "pulling" fabric.
Solution:
Don't manually push/pull fabric in order to sew, but allow the machine's feed teeth to draw fabric under the
presser foot as you guide it.
Needle Threader Not Working
Possible cause:
Needle not in correct position.
Solution:
Raise needle to its highest position by turning hand wheel toward you.
Possible cause:
Wrong size needle for fabric.
Solution:
Needle all the way up in the needle clamp.
Possible cause:
Needle is bent.
Solution:
Remove the bent needle, insert new needle.
Possible cause:
Hook pin damaged.
Solution:
Needle Threader needs replacement. Contact authorized service center.
Skipping Stitches
Possible cause:
Needle inserted incorrectly.
Solution:
Check that flat side of needle top is toward back of machine and needle is up as far as it can go, then tighten
needle clamp screw.
Possible cause:
Wrong needle for fabric sewn.
Solution:
Use correct needle style and size for your fabric.
Possible cause:
Bent, dull or damaged needle.
Solution:
Discard needle and insert new needle.
Stitches Distorted
Possible cause:
"Pushing" or "pulling" the fabric.
Solution:
Don't manually push/pull fabric in order to sew, but allow the machine's feed teeth to draw fabric under press-
er foot as you guide it.
Possible cause:
Incorrect stitch length setting.
Solution:
Adjust stitch length setting.
Possible cause:
Stabilizer may be needed for technique.
Solution:
Place stabilizer underneath fabric.
Thread Bunching at Beginning
Possible cause:
Top and bobbin threads have not been properly placed underneath presser foot before starting to sew.
Solution:
Ensure that both the top thread and the bobbin thread are under the presser foot and toward the back before
starting to sew.
Maintenance – 3 3
Maintenance – 3 3
English
English
Publicidad
Tabla de contenido
Solución de problemas
