Description Of Display Symbols - Ferroli CRP ZONE Manual Del Usuario

5.1 description of display symbols

RF signal - If the device is not paired with any gateway, the icon blinks
If the device is paired, but communication is not active, the icon remains off
If the thermostat is paired and connected to the gateway, the icon is on steady
Battery - The icon lights up when the batteries are nearly flat
T SET - Indicates that the value displayed in the upper digits is the desired room temperature
Automatic - Indicates that the zone temperature control mode is AUTOMATIC
(active time bands)
Manual - Indicates that the zone temperature control mode is MANUAL.
Temporary Manual - The presence of both symbols indicates TEMPORARY MANUAL
(the manual setting ends at the next time band change)
Heating - Indicates that the system is in HEATING mode.
The icon is off in case of STANDBY mode.
The horizontal bar below is activated when the zone is in heating request.
Cooling - Indicates that the system is in COOLING mode.
The icon is off in case of STANDBY mode.
The horizontal bar below is activated when the zone is in cooling request
68
EN
cod. 3542B150 - Rev 02 - 04/2022