Rf Communication - Ferroli CRP ZONE Manual Del Usuario

7. RF coMMunIcATIon

the exchange of data between the thermostat and the gateway occurs via RF communication at predetermined
intervals.
to preserve battery life, the alignment between the device CRP ZONe and CONNECT CRP occurs:
1. when the thermostat exits low consumption mode (display off).
2. within one minute of a change made on the thermostat.
3. within 10 minutes of a gateway change.
NOTE - In any case, synchronization between CRP ZONE and CONNECT CRP is ensured every 10 minutes.
In case of no communication (no pairing or no response from the gateway), the thermostat only displays the room
temperature and does not do any type of adjustment.
76
cod. 3542B150 - Rev 02 - 04/2022
EN