Temperature Sensor Calibration - Ferroli CRP ZONE Manual Del Usuario

8.3 Temperature sensor calibration

the thermostat makes it possible to correct the room temperature measurement by entering an offset between -9.9°C
and +9.9°C, with steps of 0.1°C. the default value is set to 0.0°C.
to change the offset value, from the basic display hold down the button
it.
the display shows:
1. the correction value (b "fig. 30"),
modifiable with the buttons
2. the measured temperature (a "fig. 30") to which
the set correction "b" is applied.
after a few seconds from the last press of a button, the
selected value is saved and the basic display returns.
the function is active regardless of the thermostat pair-
ing status with a gateway.
;
cod. 3542B150 - Rev 02 - 04/2022
for more than 5 seconds and release
a
b
fig. 30
81
EN