Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL USING LATCH/UAS: 5–35 lb (2.3–15.8 kg)
DO NOT
install by this method for a child weighing
more than 35 lb (15.8 kg). Reinstall with vehicle belt
for weights between 35–50 lb (15.8–22.7 kg).
1. Install detachable rear-facing
base (page 31). Remove
LATCH/UAS strap from
storage location
1
on back of
seat. Use LATCH/UAS release
on LATCH/UAS connectors
and pull up to remove.
2. Extend the LATCH/UAS strap.
For easier installation, extend
the LATCH/UAS strap to its
maximum length by pressing
the grey button and pulling on
the strap.
34
radian 3RX
3. Place LATCH/UAS strap for
4. Place car seat rear-facing
1
5. Slide the LATCH/UAS strap
1
6. Attach LATCH/UAS
3 2
access to rear-facing belt
path. From back of seat,
unfasten the right side of the
cover from seat shell. Feed
LATCH/UAS connectors down,
keeping under the cover and out
the bottom. Once completed,
refasten the cover to seat shell.
in back seat of the vehicle.
Center the car seat between
the vehicle LATCH/UAS
anchors. The entire seat bottom
should sit flat on the vehicle seat.
through the rear-facing belt
path and out the other side.
The LATCH/UAS strap should
lie flat and not be twisted.
connectors to vehicle
LATCH/UAS anchors and
listen for audible "click" to
confirm engagement.
diono.com
4 3
5 4
6 5
7 6
35
Publicidad
Tabla de contenido
