Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Unhook and remove top
tether strap from storage
location
2
on back of seat.
4. Feed LATCH/UAS connectors
into forward-facing belt path.
The LATCH/UAS connectors
are easier to feed through by
routing behind cover.
5. Place car seat forward-facing
in back seat of the vehicle.
Center the car seat between
the vehicle LATCH/UAS
anchors. The entire seat
bottom should sit flat on the
vehicle seat.
6. Loosely attach tether strap. Do
not tighten. Consult vehicle's
owner manual for specific
location.
48
radian 3RX
7.
2
3
8. Tighten the LATCH/UAS strap.
7 4
9. Test for tightness.
5 5
6 6
Attach LATCH/UAS
connectors to vehicle's
LATCH/UAS anchors and listen
for audible click to confirm
engagement. LATCH/UAS
strap should lie flat and not be
twisted.
Press down firmly in the center
of the car seat while tightening
the LATCH/UAS strap. You may
need to tighten through the
opening in the cover by the
belt path shown, by
own, by pulling it
pulling it
through and up.
through and up.
Grab the side of the seat with
one hand where the LATCH/
UAS strap is and slide the car
seat side-to-side and front-
to-back. If the seat moves
less than 1 in. (2.5 cm), it is
tight enough. Do not test by
grasping the top or front of the
seat.
diono.com
8 7
9 8
10 9
49
Publicidad
Tabla de contenido
