Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. IMPORTANT!
Tighten the
vehicle seat belt.
Press down firmly in the
center of the car seat. To
tighten, pull on the loose end
of the vehicle lap/shoulder
belt.
4. Test for tightness.
Grab the side of the seat
where the vehicle seat belt is
and slide the car seat side-
to-side and front-to-back. If
the seat moves less than 1 in.
(2.5 cm), it is tight enough. Do
not test by grasping the top or
back of the seat.
38
radian 3RX
3
1. Place car seat rear-facing in
4
2. Slide the vehicle seat belt
INSTALL USING 5-POINT HARNESS WITH:
LAP BELT: 5–50 lb (2.3–22.7 kg)
back seat of the vehicle with
detachable rear-facing base
installed (page 31). The entire
seat bottom should sit flat on
the vehicle seat.
through the rear-facing belt
path and out the other side.
Buckle it. The seat belt should
lie flat and not be twisted.
diono.com
1
2
39
Publicidad
Tabla de contenido
