Technical Data; Noise Information - Worx WX523 Manual Original

TECHNICAL DATA

Type WX523 WX523.1 WX523.9
(5-designation of machinery, representative
of Saw)
Rated voltage
No load (rated) speed
TCT blade
HSS blade
Blade size
Abrasive
cutting
disc
Max.cutting depth
Wood
Aluminum
Recom-
mended
PVC pipe
maximum
(diameter)
material
thickness
Tile
Sheet steel
Laser battery model no.
Bare tool weight
Spindle thread size
TCT blade
HSS blade
Saw blade
thickness
Abrasive
cutting
disc
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.

NOISE INFORMATION

A weighted sound
pressure
A weighted sound
power
K & K
PA WA
Wear ear protection.
Lithium-Ion Cordless Circular Saw
WX523
WX523.9
WX523.1
20 V Max**
2500/min
85mmx1.2mmx15mmx24T
85mmx1.2mmx15mmx44T
85mmx1.2mmx15mmx60G
27mm
27mm
3mm
13mm
8mm
0.91mm
LR44 1.5V
2.0kg 1.6kg
M6
0.8mm
0.65mm
0.8mm
L :92.0dB(A)
pA
L : 103.0dB(A)
wA
3.0dB(A)
VIBRATION INFORMATION
(CUTTING WOOD/CUTTING
METAL)
Vibration total values (triax vector sum) deter-
mined according to EN 62841:
Vibration emission value a
5,480m/s
Cutting
wood
Uncertainty K= 1.5m/s²
Vibration emission value a
4,628m/s
Cutting
metal
Uncertainty K= 1.5m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
=
h,W
2
=
h,W
2
EN
15