Work Area Safety; Electrical Safety; Personal Safety - Husqvarna DE 110i Manual De Usuario

• Do not put objects into the air slots of the battery
charger.
• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Do not charge non-rechargeable batteries in the
battery charger or use them in the machine.
• Use approved mains sockets that are not damaged.

Work area safety

• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• Do not operate the product in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. The product create sparks
which may ignite the dust or fumes.
• Keep children and bystanders away while operating
the product. Distractions can cause you to lose
control.

Electrical safety

WARNING:
appliance to rain or wet conditions.Water
entering a an electric appliance will increase
the risk of electric shock.
• The plug on the supply cord of the appliance must
match the outlet. Do not change the plug in any way.
Do not use adapter plugs with earthed (grounded)
appliances. Unmodified plugs and matching outlets
reduce risk of electric shock.
• Insert the plug in a suitable earthed/grounded power
outlet which has been correctly and safely installed
and is in compliance with local regulations. If you
are in doubt about the effectiveness of the power
outlet's earth/ground connection, have it checked by
a qualified specialist.
• Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, cookers, stoves
and refrigerators. There is an increased risk of
electric shock if your body is earthed or grounded.
• Check to ensure that the supply cord does not lie in
a puddle of water.
• Check the appliance's supply cord at regular
intervals and have it replaced by the manufacturer or
his agent if damage is found. Check extension cords
at regular intervals and replace them if found to be
damaged.
• Do not touch the supply cord or extension cord if
they are damaged while working. Disconnect the
supply cord plug from the power outlet. Damaged
supply cords or extension cords present a risk of
electric shock.
• Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the appliance. Keep
the cord away from heat, oil, sharp edges or moving
parts. Damaged or entangled cords increase the risk
of electric shock.
1618 - 004 - 24.01.2022
Do not expose the
• When operating an electric appliance outdoors, use
only extension cords of a type suitable for outdoor
use. Use of an extension cord suitable for outdoor
use reduces the risk of electric shock.
• In the event of an interruption in the electric supply,
switch the appliance off and unplug it from the power
outlet.
• Never operate the appliance when it is dirty or wet.
Dust (especially dust from conductive materials) or
dampness adhering to the surface of the appliance
may, under unfavorable conditions, lead to electric
shock. Dirty or dusty appliances should thus be
checked by an approved service agent at regular
intervals, especially if used frequently for working on
conductive materials.
• If operating an appliance in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of a RCD reduces the risk of
electric shock.
• Do periodic electrical safety tests on the product.
Refer to local regulations for the correct procedure.

Personal safety

• Stay alert, watch what you are doing and use
common sense when operating the product. Do not
use the product while you are tired or under the
influence of drugs, alcohol or medication. A moment
of inattention while operating the product may result
in serious personal injury.
• Use personal protective equipment. Always wear
eye protection. Protective equipment such as dust
mask, non-skid safety shoes, hard hat or hearing
protection used for appropriate conditions will reduce
personal injuries.
• Prevent unintentional starting. Ensure the switch
is in the off-position before connecting to power
source and/or battery pack, picking up or carrying
the product. Carrying the product with your finger on
the switch or energizing the product that have the
switch on invites accidents.
• Remove any adjusting key or wrench before turning
the product on. A wrench or a key left attached to
a rotating part of the product may result in personal
injury.
• Do not overreach. Keep proper footing and balance
at all times. This enables better control of the
product in unexpected situations.
• Dress properly. Do not wear loose clothing or
jewellery. Keep your hair and clothing away from
moving parts. Loose clothes, jewellery or long hair
can be caught in moving parts.
• If devices are provided for the connection of dust
extraction and collection facilities, ensure these are
connected and properly used. Use of dust collection
can reduce dust-related hazards.
• Do not let familiarity gained from frequent use of
tools allow you to become complacent and ignore
tool safety principles. A careless action can cause
severe injury within a fraction of a second.
13