Husqvarna DE 110i Manual De Usuario página 20

Maintenance
Do the filter purge procedure. Refer to
To remove dust particles from the prefil-
ter during operation on page 18 .
Look for signs of wear or damage of the
dust release rubber cone.
Look for signs of wear, damage or loose
connections of the controls before the
unit is connected.
Do a check of the hose and the hose
connectors.
Look for signs of wear or damage of the
plastic parts.
Do a check of the lifting eyes.
Make sure that the Longopac is correct
and that it is correctly attached. Refer to
To install a new Longopac bag cassette
on page 19 .
Do a check of the filter purge function.
Do a check of the wheels. Look for
damage and bad connections.
Do a check of the filter seals
Do a check of the connections between
the battery and the product. Do a check
of the connection between the battery
and the battery charger.
Do the filter purge procedure. If the suc-
tion continues to be not sufficient, clean
the prefilter with water. Refer to
move dust particles from the prefilter
during operation on page 18 .
Replace the cleaned prefilter if the suc-
tion continues to be not sufficient. Refer
To replace the prefilter on page 21 .
to
Replace the HEPA filter.
Replace the dust release rubber cone.
Replace filter cleaning rubber parts.
To do a check of the control panel
1. Push and hold the On/Off button until the green LED
Functions of the control panel on
comes on. Refer to
page 17 .
2. Push and hold the On/Off button until the green LED
goes off.
20
Before
each use
X
X
X
X
X
X
To re-
Daily Weekly suction is
X
X
X
X
To do a check of the battery charger
1. Make sure that the battery charger and the power
supply cord is not damaged. Look for cracks and
other defects. (Fig. 39)
When Each 6
months or months or
low 600 h
X
X
X
X X
1618 - 004 - 24.01.2022
Each 12
2000 h
X
X
X