Bluetooth ® Wireless Technology - Husqvarna DE 110i Manual De Usuario

5. Make sure that the product is installed correctly.
6. Make sure that the battery is fully charged.
To attach the dust extraction hose
WARNING:
prevent antistatic effects.
1. Open the hose connector. (Fig. 12)
2. Put the hose adapter in the hose connector. (Fig. 13)
3. Push the hose adapter until you hear a click to get it
in correct position.
To remove the dust extraction hose
• Push the hose lock button (A) and pull the dust
extraction hose. (Fig. 14)
To attach and adjust the floor nozzle
1. Put the end of the handle fully into the shaft of the
floor nozzle. (Fig. 15)
2. Turn the knob (A) at the rear of the floor nozzle
to adjust the floor nozzle wheels. Different surfaces
and different types of dust and materials make it
necessary to adjust the wheels to get the best
performance. (Fig. 16)
®
Bluetooth wireless technology
Products with built-in Bluetooth
can connect to mobile devices and enables additional
functions from Husqvarna connect.
Bluetooth
The symbol for
on when your mobile device is connected to the product.
(Fig. 17)
To use embedded connectivity with
fleet
Note:
This part is applicable only for products
supplied with embedded connectivity.
Note:
Radio transmission by the Bluetooth
will be enabled on the first time of connection to a power
outlet, and stay on after that.
1. Download the Husqvarna Fleet Services iOS or
Android app Husqvarna Fleet Services.
2. Go to Husqvarna Fleet Services website https://
fleetservices.husqvarna.com for more information.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
1618 - 004 - 24.01.2022
Use an antistatic hose to
®
wireless technology
®
wireless technology comes
®
function
Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To connect the battery to the battery
charger
Note:
Charge the battery if it is the first time that you
use it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger. (Fig. 18)
3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
(Fig. 19)
4. When all LEDs on the battery come on, the battery is
fully charged. (Fig. 20)
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
To lock and unlock the transport
wheels
For operation on a surface with a slope it is necessary to
lock the transport wheels.
WARNING:
must be clean and without dust for safe
operations. Refer to
on page 19 .
1. Hold the product in a stationary and safe position.
2. Push down the wheel brake on each side to lock the
wheels. (Fig. 21)
Note:
DE110i has only 1 wheel brake.
3. Pull up the wheel brakes to unlock the wheels.
Functions of the control panel
The control panel controls and monitors important
functions and setups of the product. Refer to
on the control panel on page 23 to find solutions for the
warnings.
(Fig. 22)
1. The prefilter is clogged. Refer to
particles from the prefilter during operation on page
18 .
Wheels and bearings
Maintenance schedule
Warnings
To remove dust
17