To Clean The Product; Filter Replacement - Husqvarna DE 110i Manual De Usuario

To do a check of the battery and the
battery holder
CAUTION:
the battery charger with water.
1. Clean the battery and the battery holder with a soft
brush. (Fig. 40)
2. Clean the cooling slots and battery connectors.
3. Make sure that the battery is not damaged and there
are no other defects, such as cracks. (Fig. 41)

To clean the product

Operation can cause contamination on all parts of the
product and all used equipment. Thus it is necessary to
clean all parts of the product and all used equipment
fully and carefully.
WARNING:
from the power supply.
WARNING:
it is moved from the work area. Remaining
dust on the product can go into the air and
cause a health risk.
• Use personal protective equipment. Refer to
Personal protective equipment on page 15 .
• Do not clean the product with a high-pressure
washer or compressed air.
• Clean the external surface with a moist cloth.
• Do not use water on electrical components.
• Clean the filters as given in
water on page 21 and To replace the HEPA filter on
page 21 .
• After servicing, put discarded parts in plastic bags.
Refer to local regulations for the correct procedure.
• If you use water to clean the product, remove the
prefilter and the Longopac before you clean. Also
make sure that no water goes into the HEPA filter.
To clean the prefilter with water
CAUTION:
washer or compressed air to clean the
prefilter. Do not hit the prefilter with force to
clean it.
CAUTION:
sunlight. The seals will dry out.
1618 - 004 - 24.01.2022
Do not clean the battery or
Disconnect the product
Clean the product before
To clean the prefilter with
Do not use a high-pressure
Do not let it dry in full
Note:
To clean the with water will gradually decrease
the efficiency of the filter.
1. Loosen the cover locks (A) and open the prefilter
cover (B). (Fig. 42)
2. Remove the prefilter. (Fig. 43)
3. Clean the prefilter with running water from the inner
surface of the prefilter. (Fig. 44)
CAUTION:
must not be higher than 4 bars.
CAUTION:
across the filter surface as this will do
damage to the filter.
4. Let the prefilter dry fully.
CAUTION:
100% dry before you install it into the
housing.
5. Install the prefilter, close the prefilter cover and
tighten the cover locks.
If the prefilter cannot be fully cleaned or if it is damaged,
it must be replaced. Refer to
page 21 .

Filter replacement

WARNING:
equipment. Refer to
equipment on page 15 . Dangerous dust can
release into the air during filter replacement.
WARNING:
disconnect the power supply before filter
replacement.
To replace the prefilter
1. Remove the prefilter. Refer to
with water on page 21 .
2. Put the prefilter carefully in a plastic bag.
3. Discard the plastic bag correctly. Refer to local
regulations.
4. Install the new prefilter.
If the suction is not sufficient when a new prefilter is
installed, it is necessary to replace the HEPA filter. Refer
To replace the HEPA filter on page 21 .
to
To replace the HEPA filter
The HEPA filter cannot be cleaned. It is always
necessary to replace it with a new HEPA filter. Only use
HusqvarnaHEPA filters.
The water pressure
Do not hit or drag items
The prefilter must be
To replace the prefilter on
Use personal protective
Personal protective
Stop the product and
To clean the prefilter
21