Beper P101COS001 Manual De Instrucciones página 25

Pressure Multicooker Use Instructions
To avoid injury and damage to the device, make sure the pressure valve is not covered or blocked
during operation. When opening the pressure valve, be sure to keep your head, hands and other
parts of your body away from escaping steam.
First use
Remove all packaging and proceed with cleaning as indicated in the appropriate section.
Secure the condensation water container to the outside of the main unit (Fig.D).
Turn the cover clockwise to open it (Fig.E), the symbol
symbol .
Remove the container for cleaning and reinsert it, making sure it touches the bottom of the main unit.
Insert the power cable into the electrical connection (Fig.F).
Connect the power plug to a suitable power outlet.
Lid closure
Place the lid on the main unit using the handle.
Make sure the lid and base unit symbols match (Fig. C). The pin must be on the left side.
Turn the cover counter clockwise towards the symbol
process. Once the lid is fully closed, the pin does not pop out.
With the help of the lid lever, the lid can be inserted into the lid holder (Fig.H).
Test run
Before starting to use the pressure cooker regularly, a test run should be started. This will allow you
to familiarize yourself with the appliance and ensure that it is working properly.
Place the container in the main unit and fill it with approximately 750ml of water.
Close the lid well and close the pressure valve by turning it to the left or right to the locking position:
the symbol placed on the valve cover must correspond to the symbol
Press the Manual button 8 times to select the Steam/Egg program. Then, using the + and - buttons,
set the duration to 2 minutes. The time is set correctly when the display shows P: 02.
After about four seconds, the pressurization/heating phase begins. During the ongoing process, an
animation appears on the display.
If steam constantly escapes from the pressure valve during this process, check the position of the
valve and close it if necessary, by turning it to the left or right.
Once the working pressure is reached, the display will show P: 02 again. The selected program
starts, and the timer counts down in 1-minute intervals.
During cooking, the pot may start a pressurization/heating process again. An animation appears on
the display again, but no action is required.
When the process is complete, the pressure cooker emits ten beeps and the Keep Warm program
starts automatically. End the test run by pressing the Keep Warm/Cancel button.
Open the pressure valve by turning the valve cover to the left or right to the
the pressure. Now you can remove the lid.
Caution: If the pressure cooker is still under pressure, do not remove the lid. If necessary,
open the pressure valve again and let the steam out. The lid must be easily removable.
must be in correspondence with the
to lock it. The lid pin will move during this
25
EN
(Fig. G).
symbol and release