Product Set Up; Product Use - Graco BREAZE LITE 2 Manual De Instrucciones

Product Set Up

To Open Stroller
See images 1 - 3
• Check the stroller frame is completely
latched open before continuing.
Rear Wheels
See images 4 - 8
To Attach and Remove
Front Wheels
See images 9 10
To Set Up Canopy
See image
11 12
To Attach and Remove
Armbar
See images
13 14
• Be careful not to install the armbar
upside down.

Product Use

To Use Canopy
See images
15 16
To Recline Backrest
See images 17 18
To Secure Child - 5 Point
Harness
See images 19 - 21
• To avoid serious injury from falling or
sliding out, always secure your child
with harness.
• DO NOT cross the shoulder belts. This
will cause pressure on child's neck.
• Make sure the harness is adjusted
properly and your child is snugly
secured. The space between the child
and the shoulder harness should be
about the thickness of one finger.
To Adjust Shoulder
Harness Position
See images 22 - 24
• In order to protect your child from
falling out, after your child is placed
into the seat, check whether the
shoulder and waist harnesses are at
proper height and length.
• For larger child, use shoulder harness
anchor A and the highest shoulder
slots.
• For smaller child, use shoulder harness
anchor B and the lowest shoulder slots.
• To adjust the position of the shoulder
harness anchor, turn the anchor to be
level with the short side facing forward.
Thread it through the shoulder harness
slot from back to front. 23 Rethread it
through the slot that is closest to child's
shoulder height. 24
Brake
See images 25 26
• Always apply the brake when the
stroller is stopped. Push the stroller
slightly to ensure the brake is engaged.
Swivel Wheels
See images 27 28
• It is recommended to use the front
swivel locks on uneven surfaces.
To Fold Stroller
See images 29 - 32
9
To Attach and Remove
Graco® Click Connect™
Infant Car Seat (8AG/ 8AV/
8AO)
See images -
33 36
• Insert Graco® Click Connect™ infant car
seat into stroller and push down on
infant car seat until the latches snap
into the Click Connect™ mounts. 34
To Use Rain Cover
See image
37
• Before using the rain cover, please
make sure the backrest has been
adjusted to the lowest position and the
infant child restraint has been fastened.
• When using the rain cover, please
always check its ventilation.
• When not in use, please check that the
rain cover has been cleaned and dried
before folding.
• Do not fold the stroller after assembling
the rain cover.
• Do not place your child into the stroller
assembled with rain cover during hot
weather.
- 2
10