Sony FW-100BZ40J Manual De Instalación página 10

3
Attach the Wall-Mount Bracket
(not supplied) using the screws
(not supplied).
Wall-Mount Bracket
(not supplied)
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the LCD Monitor
cabinet.
4
Detaching the Table-Top Stand
from the LCD Monitor.
To detach the Table-Top Stand from the LCD
Monitor, remove the screws
Note
• Be careful when lifting the LCD Monitor as the
Table-Top Stand is detached, the Table-Top Stand
may topple over and cause personal injury.
• Take care when removing the Table-Top Stand from
the LCD Monitor to prevent it from falling over and
damaging the surface that the LCD Monitor is
sitting on.
• Do not remove the Table-Top Stand for any reason
other than to install corresponding accessories on
the LCD Monitor.
• Be sure the LCD Monitor is vertical before turning
on. To avoid uneven picture uniformity do not
power on the LCD Monitor with the panel facing
down.
• When attaching the Table-Top Stand again, be sure
to fasten the screws (previously removed) to the
original holes on the rear of the LCD Monitor.
10
(GB)
Screw (not supplied)
.
FW-75BZ30J / 65BZ30J / 55BZ30J / 50BZ35J /
50BZ30J / 43BZ35J / 43BZ30J
1
Remove the screws from the
rear of the LCD Monitor.
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the LCD Monitor
cabinet.
2
Attach the Wall-Mount
Attachment (supplied with the
LCD Monitor) to the rear of the
LCD Monitor (to make it parallel
with the wall).
Supplied with the
LCD Monitor
Wall-Mount
VS
Attachment (4)
VS
1.5 N·m
{15 kgf·cm}