Floor Cleaning; Wall Cleaning; Replace The Bristle Crown; Accessories And Spare Parts - Kärcher FR Classic Manual De Instrucciones

 Remove the protective grid.
 Install / replace the high pressure noz-
zles.
 Mount the protective grid on the pin.
 Push the safety clamp in until it locks.

Floor cleaning

Mount the spray lance
Figure 3, see cover page
 Connect the spray pipe of the high pres-
sure cleaner to the FR Classic and
tighten it with a wrench (width 24).
Application
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.
ATTENTION
Do not run over protruding corners!
The surface cleaner is not suitable for
scouring or scrubbing!
Outdoor surfaces should be swept before
the surface cleaner is used to avoid damag-
ing the high-pressure nozzles.

Wall cleaning

Figure 4, see cover page
1 Adapter (order no. 4.402-022.0)
2 Hand spray gun
 Screw the adapter to the connection
and tighten it with a wrench (key width
22).
 Screw the hand spray gun on the adapt-
er, align it and tighten it with a wrench
(key width 27).
Figure 5, see cover page
 Hold the appliance at the handle while
cleaning the wall.
 Protect the appliance against frost.
 Do not allow bristles to deform during
storage.
6
Care

Replace the bristle crown

Figure 6, see cover page
 Pull the used bristle crown out of the
casing.
 Insert the new bristle crown into the
casing. Ensure correct seating (flush).

Accessories and Spare Parts

Only use original accessories and spare
parts, they ensure the safe and trouble-free
operation of the device.
For information about accessories and
spare parts, please visit www.kaerch-
er.com.
– 2
EN