Emptying Waste Container; Turn Off The Appliance; Transport; Storage - Kärcher KM 90/60 R Bp Manual Original

CAUTION
To avoid damaging the floor, do not contin-
ue to operate the sweeping machine in the
same position.
Note: To achieve an optimum cleaning re-
sult, the driving speed should be adjusted
to take specific situations into account.
Note: During operation, the waste contain-
er should be emptied at regular intervals.
Note: When cleaning surfaces, only lower
the roller brush.
Note: Also lower side brush when cleaning
along edges.
Sweeping with sweep roller
 Set programme switch to step 2. Roller
brush is lowered.
Note: Roller brush starts operating au-
tomatically.
Sweeping with bulk waste flap raised
Note: To sweep up larger items up to a
height of 50 mm, e.g. cigarette packs, the
bulk waste flap must be raised briefly.
Raising bulk waste flap:
 Press the pedal for the bulk waste flap
forwards and keep pressed down.
 To lower it, take foot off pedal.
Note: An optimum cleaning result can
only be achieved if the bulk waste flap
has been lowered completely.
Sweeping with side brushes
 Set programme switch to step 3. Side
brushes and roller brush are lowered.
Note: Roller brush and side brush start
operating automatically.
Sweeping dry floors
 Close wet/dry flap
Sweep in fibrous and dry waste (such as
dry grass, hay)
 Open wet/dry flap.
Note: You can thus prevent the filter
system from getting blocked.
Sweeping damp or wet floors
 Open wet/dry flap.
Note: This protects the filter from mois-
ture.
Filter dedusting
The appliance is equipped with an auto-
matic filter cleaning system.
The cleaning takes place automatically ap-
prox. every 15 seconds. In the process a
short blow-off sound can be heard.
 Check the installed dust filter for con-
tamination every once in a while. Re-
place a heavily contaminated or
defective filter.
22

Emptying waste container

Note: Wait until the automatic filter shaking
process is finished and the dust has settled
before you open or empty the waste con-
tainer.
 Raise the waste container slightly and
pull it out.
 Empty waste container.
 Push in the waste container and lock it.
 Empty opposite waste container.

Turn off the appliance

Note: After switching off the appliance, the
dust filter is automatically cleaned. Wait for
approx. 2 minutes before opening the appli-
ance cover.
 Set programme switch to step 1 (driv-
ing). The side brush and roller brush are
raised.
 Turn main key to "0" and remove it.
Note
2
The appliance has an automatic switch-off
function to protect the batteries from dis-
charging. If the appliance is not in use (with
1
the key switch turned on) for longer than 30
minutes, it will switch off automatically.
DANGER
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
NOTICE
Observe markings for fixing points on base
frame (chain symbols). When loading or
unloading the machine, it may only be op-
erated on gradients of max. 12%.
 Turn main key to "0" and remove it.
 Secure the wheels of the machine with
wheel chocks.
 Secure the machine with tensioning
straps or cables.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Transport

7
-
EN

Storage

DANGER
Risk of injury and damage! Note the weight
of the appliance in case of storage.

Shutdown

If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
 Park the sweeper on an even surface.
 Set programme switch to step 1 (driv-
ing). The roller brush and side brushes
are raised to prevent the bristles being
damaged.
 Turn main key to "0" and remove it.
 Lock the sweeper to ensure that it does
not roll off.
 Clean the inside and outside of the
sweeper.
 Park the machine in a safe and dry
place.
 Disconnect battery.
 Charge battery and recharge it approx.
every 2 months.

Care and maintenance

General notes

 First switch off the appliance and re-
move the key before performing any
cleaning or maintenance tasks on the
appliance, replacing parts or switching
over to another function.
 Pull out the battery plug or clamp the
battery while working on the electrical
unit.
– Maintenance work may only be carried
out by approved customer service out-
lets or experts in this field who are famil-
iar with the respective safety
regulations.
– Mobile appliances used for commercial
purposes are subject to safety inspec-
tions according to VDE 0701.
– Use only roller brushes/ side-brushes
that are provided with the appliance or
specified in the Operations Manual.
The use of other roller brushes/ side-
brushes can affect the safety of the ap-
pliance.

Cleaning

CAUTION
Risk of damage! Do not clean the appliance
with a water hose or high-pressure water jet
(danger of short circuits or other damage).
Do not use aggressive and abrasive deter-
gents.
Cleaning the inside of the machine
Danger
Risk of injury! Wear dust mask and protec-
tive goggles.
 Open the device hood.
 Blow through machine with com-
pressed air.
 Clean the machine with a damp cloth
which has been soaked in mild deter-
gent.
 Close cover.