Safety Instructions; Symbols On The Machine; Description Of The Appliance; Cleaning Floor Surfaces - Kärcher T 50 Manual De Instrucciones

Safety instructions

Please read and comply with these
original instructions prior to the initial
operation of your appliance and store them for
later use or subsequent owners.
Please observe the safety instructions of
your high-pressure cleaner.
Only trigger the high-pressure jet at the high-
pressure gun if the T-Racer is located on the
surface to be cleaned.
There must be no persons in the immediate
vicinity of the cleaning head.
Beware of the recoil force! Ensure a stable
position and firmly hold the high-pressure
gun with the extension tube or the handle.
Switch off the high-pressure cleaner when
you finish cleaning. If you are using the T-
Racer then disconnect the same from the
high-pressure gun.
Maximum water temperature 60°C (please
observe the instructions of your high-pres-
sure cleaner).

Symbols on the machine

Danger!
Do not hold under the edge of the T-
Racer when it is on!

Description of the Appliance

1 Casing
2 Bayonet connection with safety cover
3 Extension tube
The T-Racer is ideally suited for the cleaning of
floor and wall surfaces made of different materi-
als, such as wood, plastic, concrete, tiles, and
natural stone. Use the T-Racer exclusively in
your private household.
4 English

Cleaning floor surfaces

Fasten the T-Racer to the high-pressure gun us-
ing the extension pipe.
Press the extension tube into the bayonet
connection of the high-pressure gun, then
turn by 90° until it locks into place.
Tighten the safety cover.
Repeat this process even for the other con-
nections.
Caution
Do not run over free-standing corners!
The T-Racer is not suited for scouring or
scrubbing!
Outdoor surfaces should be swept before
the T-Racer is used to avoid damaging the
high-pressure nozzles.