Installation Overview - G-U B-2156 Serie Manual De Instrucciones

Operating instructions
B-2156x | B-2157x
Motor-driven lock for timber and steel doors
+60°C
°C
-20°C
≤95%
40°C
IP30 IP30
EN
III
50131-1 50131-1
III
EN
(96 hrs.)
1670 1670
NOTE
42
3.2

Installation overview

Handling the lock during the shell construction phase
„ Protect the lock against moisture and vibrations.
„ Do not allow the lock to be dropped or hit.
„ Do not drill into the door leaf if the lock is installed.
„ Never use a hammer or similar for the installation of the square spindle.
„ Never lift or carry the door leaf on the lever handle.
„ Do not cover or paint over the faceplate and latchbolt.
„ Load the lever handle only by hand in the specified direction of rotation.
„ Do not operate the lever handle and cylinder locking cam at the same time.
When delivered, the lock is provided with a slotted insert. After completing the shell
construction phase, the PC insert must be replaced with a profile cylinder.
A lock with PC insert can be opened using a screwdriver.
1. Insert a screwdriver into the slot.
2. Turn the screwdriver.
The latchbolt is retracted by
the turning of the screwdriver.
EN
B 5490 0300
U 24 V DC ± 15%
max
I 1 A
max
I 20 mA
min
Duty ratio 100%
.
2
.
1
11.2021 | | Designed in Germany