Kohler Antique K-205 Guia De Instalacion página 4

2. Prepare the Site — Wall Plate(s)
NOTE: For the mirror, do not drill the mounting holes for the
second wall plate until the actual product is measured.
Determine the desired mounting location.
Mark the vertical and horizontal center lines for the accessory to be
installed. Consult the roughing-in diagrams to determine the
dimensions.
When installing multiple-post accessories, provide the required
distance between the center points.
Use a level to ensure that all center points are level.
3. Install the Wall Anchor(s)
Hold the toggle anchor flat alongside the plastic straps and slide it
through the previously drilled hole.
With one hand, pull the looped end straight out (do not pull at an
angle) so that the toggle anchor rests flush behind the wall.
Slide the clip along the straps with your other hand until the flange
of the clip is flush with the wall.
Place your thumb between the plastic straps. Wiggle the straps
side-to-side until they snap off at the wall.
Insert the enclosed bolt through the wall plate and tighten until it is
flush with the wall.
Minimum clearance behind the wall is 1–7/8" (4.8cm).
1020817-2-A 4 Kohler Co.