Maxi-Cosi Citi Modo De Empleo página 12

maxi-citi-euro-bw-1
Alter the adjuster belt (belt system) as follows:
E
To loosen:
To tighten:
Using the Maxi-Cosi Citi in the Car
G/H-5
Please pay attention to the following when installing the Maxi-Cosi Citi in the car.
• Do not use a child safety seat if the vehicle is equipped with a front airbag. This can be dangerous. This does
not apply to so-called side airbags.
• Note the difference between the lap belt (fig.G-1) and the shoulder belt (fig G-2) when installing the seat in the
car.
• Always place the seat in a rearward facing position on the passenger seat , the carrying handle must be placed in
an upright position (fig H-1)
• If the seat belt is adjustable, place it in the lowest position.
• Ensure that the front seat is in the rearmost position.
• Thread the lap belt of the 3-point seat belt across the front of the seat and through both bright blue lap belt
hooks (fig H-2) and fasten the seat belt into the buckle.
• Place the car shoulder belt around the back of the seat and hook it into the bright blue belt hook at the rear (fig.
H-3). Ensure that the car shoulder belt is behind the blue belt hook and blocked by the retaining hook (fig. H-4)
• Pull the belt tight (fig. H-5). Ensure the belt is not twisted.
• Double check that the seat belt is threaded correctly through the three bright blue belt hooks. The Maxi-Cosi Citi
is now correctly installed.
Note:
If your seat belt appears to be too short for the installation method described above, an alternative method can be
used.
• First place the seat belt behind the three bright blue belt hooks, thread the lap belt through the lap belt hooks
and the shoulder belt through the shoulder belt hook at the rear. Then fasten the seat belt into the buckle.
• Pull the seat belt tight.
• Ensure the belt is not twisted.
• Double check that the seat belt is threaded correctly through the three bright blue belt hooks. The Maxi-Cosi Citi
has now been properly installed.
Adjusting the carrying handle
I
The carrying handle has 3 positions.
Press the two buttons on either side of the carrying handle simultaneously and move the carrying handle forwards
or backwards as required. The buttons will pop up automatically when the carrying handle is in the correct position.
1 Carrying position/car position
2 Sleeping position/rocking position
3 Sitting position
Using the control button to attach seat on the Maxi-Taxi frame (16).
J
Please refer to Maxi-Taxi users manual
10
05-04-2001 15:28
• Press the adjuster at the front of the shell.
• Pull both harness shoulder belts simultaneously towards you .
• Pull the adjuster belt at the front of the shell tight until the harness belt lies firmly against the child.
• The end stop of the adjuster belt can be fastened to the belt underneath the shell (fig. F).
Pagina 4