Description; Meter Description - KPS TL300 Manual De Instrucciones

Caution
Check if the total length of testing wires is inserted into the port before a measurement.
Take out of the batteries from the cartridge if the meter will not be used or will be stored for long.
Don't expose the meter to sunlight, high temperature, humidity or dew
Clean the meter with neutral solvents or wet cloth instead of abrasives or organic solvents
Lay the meter in store only when it is dry.
Caution:
Using this appliance in an environment with a strong radiated radio-frequency electromagnetic field (approximately 3V/m ), may influence its measuring
accuracy. The measuring result can be strongly deviating from the actual value.

2. Description

The meter is applicable to the testing of the earth resistance of the power supply wires, distribution wires inside a room, electrical equipment
or appliance, which can done in two measurement modes: Bi-poles or Tri-poles, and it also can be used to measure the earth voltage.
Large digital LCD and backlights applied to the meter facilitate users to read the information on LCD. Besides, the meter is capable of storing
up to 100 groups of measurement data, which will not be lost even in case of power cuts so that the user can easily consult the historical data.
In addition, the meter can also be used to measure maximum, minimum or average and measure relatively. Auto power-off function has been
provided for it.

2.1 Meter Description

(1) Rotating Switch
It is used to selection between the measurement of earth voltage, measurement of resistance in Bi-pole method or measurement of
resistance in Tri-pole method.
(2) Key of ASP
It is used to start or cease auto power-off function.
(3) Key of LIGHT
It is used to turn on or turn off the backlight.
(4) Key of CLEAR
It is used to clear away data.
(5) LCD
It is used to display the data obtained and different symbols.
2