Device Elements; Start Up; Operation; Cleaning Operations - Kärcher NT 20/1 ME Classic Manual Original

Device elements

1 Fastening clip
2 Cartridge filter
3 Float
4 Suction head
5 Suction hose with manifold
6 Cable hook/jack for manifold
7 Hose/cable holder
8 Carrying handle
9 Suction head lock
10 Dirt receptacle
11 Steering roller
12 Chassis
13 Floor nozzle
14 Suction support
15 Main switch
16 Suction tube
17 Holder (narrow)
18 Holder (wide)
19 Power cord
20 Nameplate

Start up

ATTENTION
For vacuuming, the cartridge filter must al-
ways be installed.
Dry vacuum cleaning
– To vacuum fine dust, you can also use
an additional paper filter bag.
– When changing from wet to dry vacuum
cleaning, the wet cartridge filter must be
dried or replaced with a dry cartridge fil-
ter first.
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag.
 Insert and lock the suction head.
All manuals and user guides at all-guides.com
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
– To suck wet dirt, first remove the paper
 Plug in the mains plug.
 Switch on the appliance at the main
 Perform the cleaning operation.
– The vacuum channel is equipped with a
– When the dirt water reaches the highest
 Switch off the appliance at the main
 Release and remove the suction head.
 Empty the dirt container.
 Switch off the appliance at the main
 Pull out the mains plug.
 Empty the dirt container.
 Vacuum and wipe the appliance inside
– 2
EN
Wet vacuum cleaning
filter bag.

Operation

Turning on the Appliance
switch.

Cleaning operations

Emptying the dirt container
float.
permissible level in the container, the
suction power is interrupted.
switch.
Turn off the appliance
switch.
After each operation
and outside with a damp cloth.
11