Before Starting The Equipment; Practical Tips; Replacing The Power Cable - EINHELL TC-DS 19 Manual De Instrucciones

Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Handle
Vibration emission value a
K uncertainty = 1.5 m/s
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
Anl_TC_DS_19_SPK9.indb 14 Anl_TC_DS_19_SPK9.indb 14
= 8.110 m/s
2
h
2
- 14 -
GB

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fastening the grinding/sanding paper
(Fig. 2)
The Velcro fastener enables easy changing of
the grinding/sanding paper. Make sure that the
vacuum extraction holes on the grinding/sanding
paper and the grinding/sanding disk are aligned.
5.2 Installing the dust extractor adapter
(Fig. 3-4/Item 2)
Slip the dust extractor adapter (2) onto the vacu-
um cleaner connector (a) as shown in Fig. 3 and
lock it by twisting. Connect the dust extractor ad-
apter to a suitable dust extraction system.
6. Operation
6.1 Switching ON/OFF
Slide the switch (1) forwards to switch on the
equipment.

6.2 Practical tips

This equipment off ers particularly high perfor-
mance for the grinding/sanding of hard-to-reach
corners and edges. To grind/sand profi les and
channels you can also work with just the tip or
the edge of the grinding/sanding disk. Various
grinding/sanding papers are available, specially
designed for the diff erent types of material you
may be working on and the amount you wish to
remove from the surface. The amount removed
will depend largely on the choice of grinding/san-
ding paper and pressure applied to the grinding/
sanding disk.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
31.01.2022 10:12:20 31.01.2022 10:12:20