Operating - HyperIce Vyper Go Instrucciones De Uso

• This is not a toy. For adult use only. Do not use if injured. Consult your doctor
before using this product.
• For storage or travel, toggle power switch to OFF position.
• Please do not use the Vyper Go, or any high-intensity vibration exercise
device without first consulting with your doctor if any of the following apply:
Pregnancy, diabetes with complications such as neuropathy or retinal
damage, wear of pace-makers, recent surgery, epilepsy or migraines,
herniated disks, spondylolisthesis, spondylolysis, or spondylosis, recent
joint replacements, metal pins or plates or any concerns about your physical
health. Frail individuals and children should be accompanied by an adult when
using any vibration device. These contraindications do not mean that you are
not able to use a vibration or exercise device but we do advise you to consult
a doctor first. Ongoing research is being done to the effects of vibration
exercise for specific medical disorders. This will likely result in the shortening
of the list of contraindications as shown above. Practical experience has
shown that integration of a vibrating fitness device into a treatment plan is
beneficial in a number of cases. This must be done on the advice of and in
accompaniment with a doctor, specialist or physiotherapist.
The Vyper Go should only be charged with the double insulated, 18VDC Hyperice
charger (model number MX24Z2-1801000) that was supplied with the device.
Do not charge the Vyper Go overnight or leave the Vyper Go unattended when
charging or in use.
The Vyper Go contains a battery which must be complied with safely at an
appropriate e-waste disposal or recycling facility.
CAUTION
The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, heat above 100 C or incinerate. Dispose of
used battery promptly. Keep away from children. Do not disassemble and do
not dispose of in fire.
SAVE THESE INSTRUCTIONS
The Vyper Go is a cutting-edge fitness device that uses pressure and
high-intensity vibration to amplify the traditional foam rolling experience.
It accelerates warmup and recovery, releases tension and tightness in the
muscles, and helps to maintain full range of motion while promoting overall
wellbeing and performance.

OPERATING

To turn on, press down on the power button for three seconds until LED lights
illuminate. Press again once for speed level one, twice for speed level two
and speed three times for level three. The blue LED lights will indicate the
corresponding speed level. Do not use directly on a hard surface. Use only on
a carpeted floor or a fitness mat. To turn off, press down on the power button
for three seconds. The device is fully turned off when all the LED lights are off.
The device will turn off after 10 minutes of use. To continue use, turn device on
again and set to desired level.
CHARGING
Fully charge for two hours before first use. To charge, connect the adapter to
the charging port and plug into wall outlet. LED lights will illuminate to show
battery level and indicate active charging. LED lights will remain illuminated
when fully charged while adapter is plugged in. Device may be recharged at any
time and at any battery level. It is not recommended to fully deplete the battery
to the red LED level. Fully recharge the device monthly to best prolong battery
life. The average run-time per charge is two hours at level three, and longer at
lower levels. It is recommended to turn the device OFF while the it is not in use
or during storage and travel.