Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up / Operation / Cleaning / Storage / Warranty and service information
Note: Air may escape from the valve of the inflat-
able when removing the connection valve
not to remove the connection valve
The manometer is not calibrated. Therefore seek
a specialist facility with a calibrated device after
inflating inflatables where incorrect pressure can
be dangerous (e.g. car tyre).
Operation
Working instructions
This device is not suitable for continuous operation.
It was developed to produce air pressure, not air
volume.
For large devices, do not use the device longer
than 5 minutes without interruption to prevent
overheating and damage to the device. After-
wards allow to cool for a minimum of 20 minutes.
We recommend first inflating large products with
air to then produce the desired pressure with
the device.
If your car tyre requires a pressure over 3 bar,
do not use the device longer than 3 minutes
without interruption. Afterwards allow to cool
for a minimum of 20 minutes.
Checking the air pressure
Note: The device does not need to be connected
to the cigarette lighter to test air pressure.
Connect the connection valve
Read the air pressure on the display of the
manometer
.
2
Remove the connection valve (see "Startup").
Note: The manometer is not calibrated.
Overload fuse
In the event of overuse or malfunction the overload
fuse
in the cigarette lighter plug
11
113044_uls_Mini-Kompressor UMK 10 B2_Content_ES_IT_PT.indd 33
All manuals and user guides at all-guides.com
protect the device. Replace the fuse after resolving
. Be sure
the reason for the fuse tripping (see „Spare parts /
7
too quickly.
accessories") (see Fig. D).
7
(see "Startup").
7
Creative Marketing Consulting GmbH
warranty
Dear customer,
the warranty for this device is 3 years from the date
of purchase. In the event of product defects, you
have legal rights against the retailer of this product.
Your statutory rights are not limited in any way by
will trip to
our warranty detailed below.
5
Unscrew the tip of the cigarette lighter plug
and remove the overload fuse.
Insert the new overload fuse and reattach the
tip of the cigarette lighter plug.
Never use a fuse with a higher tripping
current. There is a fire hazard!
Cleaning
Do not spray the device with water or
immerse in water. Risk of injury due
to electric shock if moisture enters the
device.
Do not use cleaners or solvents. These could
damage the device beyond repair.
Keep the vents
and the housing of the device
3
clean.
Clean with a damp cloth or a brush.
Storage
Keep the device in a dry location and outside
the reach of children.
Be sure not to kink the power cable
air hose
to prevent damage.
9
Warranty and service
information
5
and the
4
GB/MT
33
11.06.15 16:55
Publicidad
Tabla de contenido
