(Gb) Instructions - Vivanco UR 5000 Instrucciones Para El Uso

All manuals and user guides at all-guides.com
UR 5000 UNIVERSAL CONTROLLER

(GB) Instructions

VIVANCO UR 5000 remote control for almost
all TV, audio by learning, video and other
infrared-controllable appliances
Inserting the batteries
Open the battery flap on the back of the
remote control, press
downwards, then insert 4 alkaline AAA
batteries. Check that the polarity markings on
the batteries and in the battery compartment
are correctly lined up (+=+), then close the
flap carefully. – Always use undamaged
batteries.
If 'battery' icon is shown on display, batteries
are on low level. Please replace batteries
with new ones to ensure proper functioning.
Adapting to appliances
In order to control your appliances you must
adapt or set the remote control to them.
There are three ways of doing so: direct
control code entry, code search or learn.
If your UR 5000 does not understand you, it
blinks several times and you can then repeat
the entry. Each understood entry is confirmed
by an appliance button blinking once briefly
and a beep tone.
Direct control code entry using the
enclosed list
Example: setting to control a Panasonic
television set:
1. The enclosed
example, the Panasonic Code 2551.
Please make sure you have selected the
correct list for television sets (TV).
2. To prepare code entry, press the
required appliance button, e.g. TV, the icon
(6) will change to blue colour.
3. Press and hold down P+ and
VOL- simultanously for 3 seconds until the
indicator led (2) lights up.
4. Then press the number buttons
(e.g. 2 5 5 1) in sequence.
5. Once the numbers have been
entered the lamp goes out and the remote
control is ready to control your appliance.
Vivanco GmbH, D-22926 Ahrensburg, E-Mail:
hotline@vivanco.de, Helpline: +49 (0) 4102 231135 2
the flap lightly
list gives, for