Change Password; Restore Default Settings; Software Update - Leelbox H.265 Manual Del Usuario

Change password

To change some settings (for example Parental control) you need to enter a password, by
default it is 888888, but it may be necessary to change it. To do this, press the MENU key on
the remote control, move with the arrow keys to access the SYSTEM menu, click on LOCK
CONTROL (the password is required to enter), in the new screen select CHANGE PASSWORD.
At this point, three new fields appear to be filled in with the password currently in use (OLD
PASSWORD), with the one you want to use from now on (NEW PASSWORD) and with
confirmation of the new password (CONFIRM PASSWORD). The password is a 6-digit number,
which can be entered with the numeric keypad on the remote control. Keep the password you
have just changed carefully; the old password will no longer be usable.
NOTE: if you have forgotten your password, you can use 873543, it cannot be
changed.

Restore default settings

If you want to return to the factory settings of the device, press MENU on the remote
control, using the arrow keys to access the SYSTEM menu, click on FACTORY RESET,
confirming with OK a password is requested.
ATTENTION: In this way all the settings created by the user (password, favorite channel list,
etc.) will be deleted and the decoder will return to the conditions of first use.

Software update

If an update of the device management software is available, it will be possible to install it
using a USB key (minimum 2GB).
Once the software has been saved on a USB stick, insert it into the appropriate slot on SIDE A
(Figure 1). Access the SYSTEM menu and with the arrow keys click on SOFTWARE UPGRADE,
on the new screen press OK again. Select FILE PATH and locate the file to be installed on the
key; once this is done, select START and the update will begin.
ATTENTION: do not turn off the device during the update which could take up to a few
minutes. The installation of the new software will restore the device to its factory settings
(first use condition), any settings made by the user will be deleted (new password, channel
tuning ).
ATTENTION: with the installation of the new software some features may be different.
ATTENTION: at the end of the installation, it is recommended to proceed with a factory reset
(see the chapter Restore default settings).
18