Leelbox H.265 Manual Del Usuario página 22

emitters look at each other without being obstructed
2 Press the SET button for 3 seconds on the remote control until the red LED lights up and
stays on.
3 Press the key to be associated on the decoder remote control within 10 seconds.
4 Press the button to be associated on the TV remote control within 3 seconds. If the signal
is received by the remote control, the red LED will flash 3 times and then remain on.
5 Press SET to confirm.
6 Repeat these steps for each button on the remote you want to configure
Tips:
• at the end of the programming process, check whether the key has been associated before
continuing with the next
• in order to avoid confusion, associate the keys with the same function, for example in point 3
press the ON / OFF key on the remote control of the receiver and in point 4 press the same key
on the remote control of the TV,
Attention: it is possible to associate only the buttons of the remote control supplied
inside the white rectangle (ON / OFF, TV / AV; VOL + and VOL-). SET function key and
cannot be associated.
Functions not available
Some functions may not be available in this case a window like the one shown will appear.
Troubleshooting
There can be different causes for the abnormal operation of the appliance. The
receiver may hang, in which case unplug it and wait 30 seconds before reinserting it.
If the appliance does not work properly, refer to the following tables for possible
solutions.
20