Transport; Storage; Maintenance And Care; Troubleshooting - Kärcher Xpert NT 360 Manual De Instrucciones

Filter dedusting
While vacuuming, clean the flat-fold filter at
regular intervals.
Illustration
Move the handle of the filter dedusting
back and forth a few times.
Turn off the appliance
Switch off the appliance at the main
switch.
Pull out the mains plug.
After each operation
Filter dedusting: Move the handle back
and forth a couple of times.
Empty the container.
Vacuum and wipe the appliance inside
and outside with a damp cloth.
Storing the Appliance
Wind up the suction hose and mains ca-
ble.
Place the appliance in a dry room and
secure it from unauthorized use.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Storage

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Replacing the flat-fold filter and the
exhaust filter
Open filter door.
Replace the flat pleated filter.
Replace the exhaust filter.
Close the filter door, it must lock into
place.
Cleaning the electrodes
Release and remove the suction head.
Clean the electrodes with a brush.
Insert and lock the suction head.

Troubleshooting

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Suction turbine does not run
Check the receptacle and the fuse of
the power supply.
Check the power cable, the power plug
and electrodes of the device.
Turn on the appliance.
Suction turbine turns off
Empty the container.
Suction turbine does not start again
after the container has been
emptied
Turn off the appliance and wait for 5
seconds, turn it on again after 5 sec-
onds.
Clean the electrodes as well as the
space between the electrodes with a
brush.
– 3