Metabo HPT W 18DA Instrucciones De Seguridad Y Manual De Instrucciones página 14

English
4. Working with stopper
See Fig. 8.
The depth of screw can be set by turning the setting
sleeve. On rotation of the knurled screw corresponds
to a drill depth of around 1.5 mm.
Adjust the setting sleeve so that the screw head is
approx. 2 mm outside the stop sleeve when applying
the screw.
Insert a screw as a test. Correct the screw depth if
necessary.
CAUTION
When screwing in crosshead screws, press the
machine with the bit fi rmly against the screw until the
screw is fully inserted; otherwise the bit could slip out
of the cross recess and damage the material.
Stop sleeve
Setting sleeve
1/6" (2 mm)
5. About Remaining Battery Indicator (on tool body)
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig. 9)
When releasing your fi nger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off . The Table 5 shows the state of remaining
battery indicator lamp and the battery remaining
power.
State of lamp Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power
is a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
14
Union sleeve
Fig. 8
Table 5
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Remaining
battery
indicator switch
(on tool body)
NOTE
○ When using a battery with a remaining battery
indicator, please refer to the indicator lamp on the
battery for the battery remaining power.
○ Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
○ To save the battery power consumption, the
remaining battery indicator lamp lights while pressing
the remaining battery indicator switch.
6. Remaining battery indicator (on battery)
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light
the indicator lamp. (Fig. 10, Table 6)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
State of lamp
Lights ;
The battery remaining power is
over 75%
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Remaining
battery
indicator lamp
(on tool body)
Fig. 9
Table 6
Battery Remaining Power