Prior To Operation - Metabo HPT W 18DA Instrucciones De Seguridad Y Manual De Instrucciones

CAUTION
● When the battery charger has been continuously
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes
rest until the next charging.
● If the battery is charged while it is heated
because it has been left for a long time in a
location subject to direct sunlight or because
the battery has just been used, the pilot lamp of
the charger lights for 1 second, does not light for
0.5 seconds (off for 0.5 seconds).
The battery will not be recharged. In such a case,
let the battery cool before charging.
● When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign
objects in the charger's battery connector. If
there are no foreign objects, it is probable that
the battery or charger is malfunctioning. Take it
to your authorized Service Center.

PRIOR TO OPERATION

CAUTION
To avoid serious accident, ensure the switch is in
the OFF position, and pull out the battery.
Installation of belt hook
The belt hook may be screwed into place on the left or
the right (see Fig. 2).
USE
WARNING
Wear ear protectors!
1. Setting the direction of rotation, engaging the
transporting safety device (switch-on lock)
CAUTION
Only activate the rotation selector switch when the
motor has completely stopped.
See Fig. 2.
R = Clockwise setting
L = Anti-clockwise setting
0 = Centre position: with the transporting safety
device engaged (switch-on lock)
2. Selection operating mode, switch on / off
Set the required operating mode on the dial. (see
Fig. 2)
NOTE
When the motor is running, the spindle does not start
until the spindle is pushed in.
Manual mode
Switch on: press the trigger switch. Press in the
trigger to increase the rotational speed.
To switch off release the trigger switch.
Automatic mode
The tool starts automatically when the spindle is
pushed in. This facilitates convenient work. In order
to enable automatic mode, briefl y press the trigger switch.
NOTE
The tool switches to sleep mode after 15 minutes without
use. To activate again: press the trigger switch briefl y.
WARNING
Risk of injury from inadvertent automatic
machine start-up. In automatic mode, do not
touch any rotating parts such as spindle, bit or
magnetic bit holder.
Impulse mode
Protruding screws can be precisely countersunk
using this function. Press trigger switch and
countersink the screw with the attached stopper. To switch
off release the trigger switch.
NOTE
○ If the amount of protrusion of the screw is small, the
screw may not tighten.
○ In that case, remove the stopper and make
adjustments in Manual mode.
3. Changing bit
WARNING
Prevent inadvertent starting: Set manual
mode and remove battery from the tool before
performing any retooling.
Inserting and removing the bit:
See Fig. 7.
Remove the stopper.
Insert: Insert the bit in the magnetic bit holder.
Remove: Pull the bit from the magnetic bit holder
using pliers.
Attach the stopper again:
turn and engage in position when mounted.
NOTE
The magnetic bit holder may be removed from the
spindle if the sleeve is pulled back.
Magnetic bit holder
Stopper
Bit
English
Spindle
Closure sleeve
Fig. 7
13