Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
MAINTENANCE AND INSPECTION
WARNING
Be sure to turn off the switch and pull out the battery before doing any inspection or maintenance.
1. Inspecting the bit
Continued use of a worn or broken bit may cause
overloading of the motor. Replace the bit with a new
one as soon as excessive abrasion is noted.
2. Clean stiff stopper
If the depth setting is stiff , the stopper can be
dismantled without using tools. To do this, turn the
setting sleeve clockwise until it becomes loose from
the union sleeve. Twist out the stop sleeve and clean
thread.
NOTE
Only clean or vacuum mechanically. Do not use oils or
greases.
NOTE
Regularly remove and clean the stopper.
3. Check the Screws
Loose screws are dangerous. Regularly inspect them
and make sure they are tight.
CAUTION
Using this power tool with loosened screws is
extremely dangerous.
4. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
5. Check for Dust
Dust may be removed with a soft cloth or a cloth
dampened with soapy water.
Do not use bleach, chlorine, gasoline or thinner, for
they may damage the plastics.
Particles may become deposited inside the power
tool during operation. This impairs the cooling of the
power tool.
The power tool should be cleaned regularly, often and
thoroughly through all front and rear air vents using a
vacuum cleaner. Prior to this operation, separate the
power tool from the power source and wear protective
goggles and a dust mask.
16
6. Inspection of terminals (tool and battery)
Check to make sure that swarf and dust have not
collected on the terminals.
On occasion check prior, during and after operation.
CAUTION
Remove any swarf or dust which may have collected
on the terminals.
Failure to do so may result in malfunction.
7. Lubrication
The bearings in this tool have been suffi ciently
lubricated with quality lubricating oil, taking into
account the expected life of this tool under normal
operating conditions. As a result, no further lubrication
is necessary.
8. Environmental protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
9. Disposal of the exhausted battery
WARNING
Do not dispose of the exhausted battery. The
battery must explode if it is incinerated. The
battery is recyclable. At the end of it's useful
life, under various state and local laws, it may
be illegal to dispose of this battery into the
municipal waste stream. Check with your local
solid waste offi cials for details in your area for
recycling options or proper disposal.
Publicidad
Tabla de contenido
