Metabo HPT W 18DA Instrucciones De Seguridad Y Manual De Instrucciones página 15

Lights ;
The battery remaining power is
less than 25%
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the
battery from the tool and allow it
to fully cool down.
Blinks ;
Output suspended due to failure
or malfunction. The problem
may be the battery so please
contact your dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Remaining battery
indicator lamp
Display panel
Fig. 10
Safeguard Function
Overload Protection
Temperature Protection
Remaining battery
indicator switch
LED Light Display
Blinks three times
7. How to use the LED light (Fig. 11)
The LED light will light the area at the tip of the tool
when the switch is drawn.
The LED light will automatically power off 10 seconds
after the switch is released.
LED light
CAUTION
Do not look directly into the light from the LED
lamp. Continuous and direct exposure to the
light from the LED lamp can injure your eyes.
8. LED light warning signals
This product features functions that are designed to
protect the tool itself as well as the battery. If any of the
safeguard functions are activated during operation,
the LED light will blink three times. (See Table 7)
When any of the safeguard functions are triggered,
immediately remove your fi nger from the switch and
follow the instructions described under corrective
action. After performing the corrective action, if the
product does not operate when the trigger switch is
pulled (or if the LED light blinks), remove the battery,
wait for about 10 seconds, then insert the battery
again.
Table 7
Remove the cause of the overloading.
Allow the tool and battery to thoroughly
cool.
English
Trigger switch
Fig. 11
Corrective Action
15