Replacement Of Batteries - XS Instruments Revio Manual De Instrucciones

• check that the electrical standards of the line on which the instrumentation is to be installed comply
with the voltage and operating frequency of the instrument;
• use the original power supply only;
• connect the power supply to the USB cable and the other end of the cable (Micro USB) to the Micro
USB port located on the front of the instrument;
Connect the power supply to an electric socket easy to reach.
•
ATTENTION - Danger of death or serious injury from electric shock.
Contact with live components can lead to injury or death.
• Use the adapter supplied only.
Do not put the power supply in contact with liquids nor in a condensing environment.
•
Avoid thermal shock.
All electrical cables and connections must be kept away from moisture or liquids.
•
Check that the cables and plugs are not damaged, otherwise replace them.
•
• During use, do not cover the power supply and/or do not place it inside containers.
The electricity supply can be originated from the power grid and from the USB port of a PC too.
If the instrument is powered by PC, the icon
Opening the DataLink+ software, on the display it is shown this icon
• Power on, date and time, power off
Turn on the system by pressing the button
• REVio home screen with software version.
• Settings relating to the most important parameters and possible information about the DHS sensor.
• Once the upload is complete, the device enters the measure mode.
On first use, and after each battery replacement, the instrument during the start-up phase will request
the updating of the date and time (See paragraph Instrument configuration menu):
• In measure mode press the key
again.
Use the keys and
•
Change the date using the directional keys. (See paragraph Instrument configuration menu).
• Repeat the same operation with the "Time Setting" menu.
• Press the button
• To switch off the instrument, press the key

• Replacement of batteries

The instrument works with 4 AA 1.5V batteries. To proceed with the replacement:
• Turn off the device.
• Turn the instrument over with the display facing down and place it on a stable surface.
It is advisable to put a cloth to avoid any scratching on display.
Using the screwdriver supplied, completely unscrew the screw close to the battery symbol.
•
• Remove the battery stopper cap with the help of the lanyard.
• Remove the 4 exhausted batteries and insert the new ones. Pay attention to the correct polarity. Follow
the diagram above the battery symbol in the rear compartment of the instrument.
• Reinsert the battery stopper cap; always hold it with two fingers, insert the screw and tighten.
UM ReVio EN rev.0 04.06.2020
will appear on the display.
. The display will show:
. Move the cursor over the icon
to scroll the menu until "Date setting" and access with the button
to return to measure mode.
11
.
in measure mode.
and access by pressing
.
EN