Before First Use; Important; How To Use - UFESA NUTRIBOOM Manual De Instrucciones

BEFORE FIRST USE

Before using your appliance for the first time, it is important that you read and follow the instruc-
tions in this use and care booklet, even if you feel you are familiar with this type of appliance.
Your attention is drawn in particular to the section dealing with the appliance. Find a safe and con-
venient place to keep this booklet handy for future reference. This appliance has been designed
to operate from a standard domestic power outlet. It is not intended for industrial or commercial
use. Carefully unpack the Appliance. Remove all packing materials and either discard or retain for
future use.
Ensure that the voltage of your electricity supply is the same as that indicated on the rating label
of the appliance. Remove the plastic accessories and wash in warm soapy water. Dry thoroughly
and replace. Wipe over the exterior of the Motor Base with a damp sponge or cloth. Do not use
abrasive cleaners.
CAUTION: Blades are sharp! Use extreme caution when handling the blade assemblies. Always
hold them by the base of the blade assembly.
IMPORTANT: Never run the appliance empty.
CAUTION: Never attempt to remove the jar while the appliance is still running.
WARNING: Never leave the appliance unattended while in use.
Remove all packaging material and labels from the appliance.

HOW TO USE

IMPORTANT: Make sure that the motor base is plugged in for use.
Place the motor base on a clean, dry, level surface such as a counter or table top.
Make sure the unit is unplugged, then add ingredients to the jar.
Place the blade onto the jar and twist it on tightly until you have a good seal. (Fig. 1)
Turn the jar upside down and place it onto the motor base, aligning the tabs on the jar with the
motor base, aligning the tabs on the jar with the motor base. Turn it clockwise, the unit is ready
for use. (Fig. 3)
When you have reached your desired consistency, stop the appliance by turning the jar counter-
clockwise (Fig. 4) and pull straight up to remove. (Fig. 5)
NOTE: Do not overfill! To avoid spilling, do not add ingredients past the "Max" fill line.
Turn the jar upright and remove the Blade Assembly by twisting the blade assembly countercloc-
kwise. Be sure to store the Blade Assembly attached to an empty jar when not in use.
Place the Sip & Seal lid onto the jar, twist to seal and enjoy!
Make sure that the motor base is unplugged when not in use.
WARNING: Do not operate the motor continuously for more than 60 seconds at a time. Allow the
motor to rest for 180 seconds before continuing.
To prevent product overheating, dry ingredients must not be processed for more than 30 seconds
at a time.
NOTE: The blender has a built-in safety lock feature, this ensures that you can only switch on the
appliance while the cup and the blade subassembly are assembled on the motor base securely. If
the appliance is correctly assembled, the built-in safety lock will be unlocked.
15