Cleaning And Maintenance - UFESA NUTRIBOOM Manual De Instrucciones

RECIPE
Food
Carrots
TROUBLESHOOTING
Problem
Motor doesn't start or at-
tachment doesn't rotate.
Food is unevenly cho-
pped.
Food is too finely cho-
pped or too watery
Blade is not running
smoothly
You cannot achieve snow
from ice cubes.
Jar is leaking
Unit doesn't turn on
Unit doesn't turn off
Doesn't mix well
Lid/blade assembly will
not properly align to
the jar

CLEANING AND MAINTENANCE

CAUTION: Make Sure that the motor base is unplugged from the power source before inserting or
removing any attachment and before cleaning.
Wait until the blender has cooled down sufficiently before cleaning it.
CAUTION: DO NOT immerse the motor base into water or any liquid, or place into a dishwasher.
Separate/remove all parts from each other.
Clean the motor base with a slightly damp cloth and wipe dry.
16
Maximum Amount
320g (carrots) + 480ml (water)
Analysis
For the jars, make sure that the tabs are seated in the slots and
turned clockwise
Either you are chopping too much food at once, or you are not
pulsing properly. Reduce the amount of food in the jar.
The food has been over processed. Use short operating for best
results.
Stop the product and add some liquid, or reduce the ingredients in
the cup.
For best result use ice straight from the freezer. Try using short
operating instead of long one.Make sure the jar is completely dry
before adding ice.
Make sure that your lid or blade assembly is properly assembled to
the jar. Leaking may occur if it is misaligned when twisted onto the
jar. Turn the lid tightly clockwise.
Make sure the unit is plugged in. Make sure the blade assembly is
properly assembled to the jar and that is not misaligned
Unplug the power cord from the electrical outlet and call customer
service for support
Pulse ingredients for best results. Press down on the jar in short
intervals for even blending and chopping. For frozen ingredients,
pulse in short intervals of 2-5 seconds and repeat.
Set the jar on a level surface. Place the lid or blade assembly on
top of the jar and align the threads so that the lid/blades sit flat on
the jar. Twist clockwise so that the lid/blades evenly align to the jar
until you have a tight seal.
Approx. time
1 min.