Instructions for use
All manuals and user guides at all-guides.com
4
Press and hold the Standby key of the
SRU 5020.
–
The SRU 5020 now starts emitting all known
'TV off ' signals, one by one.
Each time a code is sent, the TV key lights up.
5
When your TV switches off (stand-by), release the Standby key of the
SRU 5020 immediately.
–
The SRU 5020 has now found a code that works on your TV.
6
Check if you can operate all functions on your TV with the SRU 5020.
•
If this is not the case, you can redo the automatic setting.
The SRU 5020 will then search for a code that works better.
–
After the SRU 5020 has run through all the known codes, the search
will stop automatically and the TV key stops flashing.
–
Automatic programming of a TV takes a maximum of 5 minutes.
For DVD or VCR this time is 2 minutes.
Manually setting the remote control
Example of TV:
1
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2
Look up the brand of your TV in the
code list at the back of this manual.
One or more four-figure codes are shown for
each brand.
Note the first code.
Be careful! There are separate tables for TV, DVD
and VCR.
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
Make sure you use the codes from the correct table.
3
Press the TV key to select TV.
Press the key until it lights up.
4
Keep keys 1 and 3 pressed simultaneously
for three seconds until the TV key flashes
twice and then remains lit.
6