Routine Maintenance - Roborock Q7 Max Manual Del Usuario

Custom Cleaning Modes
• Scheduled
• Selective Room
• Zone
• No-Go Zones & Invisible Wall
• Custom
• Carpet Boost
Cleaning Mode Switch
• Suction Power Levels
• Mop Intensity Levels
Robot Information
• Cleaning History
• Battery Level
• Care & Maintenance
More Features
• Firmware Update
• Volume Adjustment
• Language Selection
• Do Not Disturb mode
• Voice Assistant Support
Note: Functions and details of the app may vary slightly
due to the continuous app development and updates.

Routine Maintenance

C
Main Brush
C1
* Clean every 2 weeks and replace every 6-12 months
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush
C1-4—Main Brush Caps
C1-5—Main Brush Bearing
C1-6—Turn over the robot and press the
latches to remove the main brush cover.
C1-7—Pull out the main brush and remove
the main brush bearing.
C1-8—Rotate the main brush caps in the
indicated unlock direction to remove
the caps.
C1-9—Remove any hair or dirt entangled
around the main brush, reinstall the
main brush and re-insert the brush
cover, making sure to place the tabs
in the slots.
C1-10—Make sure that the main brush
cover has been properly attached.
When properly installed, all four tabs
should be hidden.
Notes:
• Main brush should be wiped down with wet cloth and
left to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
Side Brush
C2
* Clean monthly and replace every 3-6 months
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
Omni-Directional Wheel
C3
* Clean as required
08
C3-1—Use a tool, such as a small screwdriver,
to pry out the axle and take out the
wheel.
Note: The omni-directional wheel bracket cannot be removed.
C3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
Main Wheels
C4
* Clean monthly
Clean the main wheels with a soft, dry cloth.
Dustbin and Water Tank
C5
Combo Unit
* Clean weekly and replace the filter every 6-12 months
C5-1—Open the upper cover of the robot
and take out the unit.
C5-2—Remove the filter then empty the dustbin.
C5-3—Empty the water tank of unused water.
C5-4—Fill the dustbin with clean water and
gently shake it. Then pour out the
dirty water.
Note: To prevent blockage, only use clean water without
any cleaning liquid.
C5-5—Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with your
hands, brush, or hard objects to avoid potential damage.
C5-6—Allow 24 hours for the filter to dry
thoroughly and reinstall it.