Hitachi RPIL-0.4FSRE Manual De Instalación Y Funcionamiento página 40

INDOOR UNITS INSTALLATION
4 Carefully separate the electrical box from the indoor unit and
softly pull the electrical hose out of the box.

Mount the electrical box on the right side
a. Loosen and remove the 3 screws holding the lower panel.
b. Remove the bottom panel and leave it somewhere that it
will not disturb.
c. Re-route the electrical hose to the inside of the indoor
unit and secure it with the pre-assembled flanges.
d. Mount the electrical box in its new location (right side)
and fasten it with the 2 fixing screws.
10 PMML0527 rev.1 - 02/2021
e. Make sure that the entire electrical hose is properly
secured and exits through the right-hand side wall opening.
!
C A U T I O N
The electrical hose must not be tightened or forced at any point in its route.
f. Mount the lower panel of the indoor unit and secure it
with the 3 fixing screws.
g. Mount the cover of the electrical box and fasten it with
the 2 fastening screws.

Mount the electrical box on the wall
a. Cut the bottom, pre-cut part of the electrical box wall
passage and move the electrical hose so that it comes
out the bottom of the electrical box.
b. Present the electrical box in its final location on the wall
and make sure that the electrical hose is attached to the
wall free of obstacles in its path.
!
C A U T I O N
The electrical hose must not be tightened or forced at any point in its route.
c. Secure the electrical box to the wall with 2 retaining
screws.