Section 8 - System Configuration; Accessing The Configuration Screens; Quick Set-Up Configuration; S02 Tab Settings - Ingersoll Rand System Automation X4I Manual De Configuración Rápida

SECTION 8 — SYSTEM CONFIGURATION

ACCESSING THE CONFIGURATION SCREENS

In order to change the configuration parameters, you will
first need to input the service access code. The service
access code is 0032. Enter this code as follows:
1. Press the menu
the Access Code Screen.
Access Code Screen
2. Adjust the first access code digit by using the
scroll up (+)
buttons. When the correct number
shows press the enter
should then move to the next digit to the right.
3. Adjust the remaining digits until the proper
access code is shown on the screen. If for any
reason you need to go back to a previous digit
press the escape
the cursor up one digit at a time.
4. When you've adjusted the final digit to the
correct number press the enter
you should see an animation of a key opening a
lock. You are now able to access the
configuration screens.
5. When in menu mode, you must press the escape
button until you are returned to the Main
menu. If you do not, the X4I remains in the
menu mode.
6. After successfully entering the access code you
should see the screen shown below. The cursor
will flash on the name of the current page (P00).
You can scroll through the tabs by pressing the
All manuals and user guides at all-guides.com
button. This will display
and scroll down (-)
button. The cursor
button. This will back
button and
scroll up (+)
buttons.
Default Configuration Screen

QUICK SET-UP CONFIGURATION

S02 TAB SETTINGS

After you have successfully entered the password and
you are at the P00 screen, scroll up (+)
down (-) until the S02 page is highlighted.

S02 TAB SCREEN

Press the enter
The cursor should be flashing on 01 P>.
S02 Home Screen
12
and scroll down (-)
button to confirm your selection.
or scroll